Legacy: Develco ZHOT101

Areas of use

A motion sensor can be used for several things. motion sensor is a multisensor that detects temperature and light levels in addition to movements. You can make a thermostat with the motion sensor along with a smart electrical outlet to control a heater or similar.


Get started with Motion sensor

Step 1. Open the cover of the sensor.

Step 2. Insert the batteries. Make sure that you are inserting the batteries according to the polarity.

Step 3. The motion sensor will now look for a Zigbee network it can connect to (it searches for networks for up to 15 minutes).

Step 4. The LED will flash red while the sensor is looking for a Zigbee network it can connect to.


Scan for Motion sensor

Step 1. Scan for new device in Wattle to connect it to your gateway. (Settings–>Manage devices)

Step 2. When the LED button stops blinking, the Motion sensor is connected to Wattle.

Configure Motion sensor

Step 1. Set a device name

Step 2. Add the device to a room.

Select the room you want from the list or add a new room.


Settings for: Security sensor

Step 3. Select Usage

Generic  The sensor is separated from any system logic. You can view the status of the sensor in the “generic” tab in the room view.

Security The sensor is used as part of the security alarm system. You can view the status of the sensor in the “sensors” tab in the room view. Usage option: select which of the armed modes this sensor will trigger.  It is possible to select one or more alarms.
Away / Stay / Night- alarm.  The sensor will trigger the alarm based on your configuration and the mode selected.


Settings for: Temperature sensor

Usage defaults to generic

Settings for: Light sensor

Usage defaults to generic

Step 4. Choose Apply when satisfied with configuration.


Resetting Motion Sensor

Reset is required if you want to connect the sensor to another gateway or reset to factory settings due to abnormal behavior. To reset the sensor, do the following:

Step 1.  Open the cover.

Step 2. Make sure the battery is inserted correctly.

Step 3. Press and hold the button (about 15 seconds) until the red LED light flashes repeatedly.

Step 4. Release the button when the light flashes continuously.

Step 5. The reset is completed when the LED starts blinking every second.


In case of poor or weak signal, try to mount the sensor closer to the gateway. You can also use a smart plug as signal repeater between the sensor and the gateway to boost the signal.

If the search for gateway has timed out, you can start it again by pressing the button.


back to Motion sensors

to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services