Smart Door Sensor
Remove the battery insulator from product to activate.
Click on the gear-symbol on your dashboard to add new device. Start device scan to search for new device.
After starting the search in the APP, press network button (pin hole) for 3 seconds to enter inclusion mode. LED will flash rapidly until device are detected by your gateway, you will see the new device appear in the search results on your app. If any issues scanning device please refer to Disconnect / Factory reset.
Align the installation. the installation distance is less than 15 mm (the magnet part can be installed both sides of detector part).
*Always mount indoors. The sensor is not water-proof.
Remove the protecting film of the adhesive tape, stick the sensor ond magnet to the required area. Sensor should be installed in a fixed area like the door frame,
magnet can be installed on the active area like the door blade. Picture for reference only.
Insert sensor into the bracket.
Please replace battery correctly, following the battery positive and negative electrode. Attention to environmental protection and dispose used battery properly.
Operating Voltage: DC3V (2x AAA battery)
Static current: ≤5uA
Alarm current: ≤30mA
Detecting distance: >15mm
Networking: ZigBee 1.2 Home Automation
Operation temperature: -10°C ~+50°C
Relative humidity: Maximum 95%RH (no condensation)
Detector dimensions: 76 x 36.6 x 16.5 mm
Magnet dimensions: 76 x 13.9 x 16.5 mm
Press ond hold the network button (pin hole) for 5 seconds to disconnect / reset the device. The LED will flash six times to indicate successfully disconnected / reset
-->
receive exclusive offers and the latest news on our products and services.
When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.