Heiman HS1HT-E

Temperature & Humidity detector

Product Introduction

Supervising indoor climate

This is a smart temperature and humidity sensor. With high precision temperature
and humidity sensor built-in, this sensor can perceive and report real-time
temperature and humidity reading to your APP. The product is suitable for
environmental monitoring of your home, office and/or cabin.

Function Effect Diagram

Step 1

Remove the battery insulator from product to activate.

Step 2

Click on the gear-symbol on your dashboard to add new device. Start device scan
to search for new device.

Step 3

Add to gateway:

After starting the search in the APP, press network button (pin hole) for 3 seconds to enter inclusion mode. LED will flash rapidly until device are detected by your gateway, you will see the new device appear in the serach results on your app. If any problems scanning device, look at “Disconnect/Factory reset” of device.

Step 4

Remove the protecting film of the adhesive tape and mount the sensor to the required area.

Step 5

Note that the mounting base should be up as the direction of arrow shown in
the graph. Finally, hang the detector into the mounting base.
*for indoor use only.

Disconnect/Factory reset:

Press and hold the network button (pin hole) for 5 seconds to disconnect / reset
the device. The LED will flash six times to indicate successfully disconnected / reset.


back to Latest generation

to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services