Setup and reset

Get started, scan, configure, mount and reset

Areas of use

Use a smart humidity sensor to monitor the humidity of your rooms to protect your belongings. The sensor also has a built-in temperature sensor. View statistics and changes and customize your actions to preserve your assets.

Instructions

Get started with Humidity sensor

Step 1. Open the cover by pressing the button and lift the cover.

Step 2. Insert the two supplied AA batteries. Observe correct polarity.

Step 3. The humidity sensor will now start looking for a gateway (a Zigbee network) that it can connect to.

Scan for Humidity sensor in Wattle app

Step 1. Scan for a new device with Wattle to add the sensor.

Step 2. The LED light will flash red while the sensor is looking for a gateway.

Step 3. When the light stops blinking, the humidity sensor is connected to a gateway. You now see the device in Wattle.

Step 4. Click Configure.

Configure Humidity sensor in Wattle app

Step 1. Set a device name

Step 2. Add the device to a room.

Select the room you want from the list or add a new room.

Settings for: Temperature sensor

Usage Defaults to generic.

Step 3. Press Apply when you are satisfied with configuration.

Placement of Humidity sensor

The sensor should be placed indoors at a temperature between 0 and 50 celsius.

Place it in the room you want to monitor the moisture level.

Humidity meter should be located on the wall so that it is easy to reach for testing the battery and maintain it.

Mounting of Humidity sensor

Step 1. Open the humidity sensor cover and remove the batteries.

Step 2. Attach the sensor to the wall using double sided tape or screws.

Step 3. Insert the batteries. Observe correct polarity.

Step 4. Make sure that the humidity sensor is connected to the gateway before attaching the cover.

Resetting Humidity sensor

Reset may be required if you want to connect the sensor to another gateway or reset it to factory settings to eliminate abnormal behavior.

Step 1. Open the sensor cover.

Step 2. Press and hold until LED light flashes continuously. About 15 seconds.

Step 3. Release the button.

Step 4. The reset is completed when the LED starts blinking every second. Scan for new device with Wattle to re-use the sensor.

Troubleshooting Humidity sensor

In case of poor or weak signal (see signal level in Wattle), try moving the sensor to another location / closer gateway.

You can also set up a signal amplifier (Zigbee) between the sensor and the gateway if the signal is poor or weak.

If the search for a gateway has timed out, you can start it again by briefly pressing once on the LED button. The smart plug will be in search mode for 15 minutes or until it finds a gateway.

back to Wattle Devices
newsletter

Subscribe
to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services