Develco ZHEMI101

The Meter Reader

Areas of use

The ZigBee-IR/LED meter serves as external ZigBee interface for
electronic meters. It collects meter readings from existing meters
already installed and sends data via ZigBee to the Wattle gateway.

This way, you can follow your energy consumption at your mobile phone.
The meter unit can be used with different kinds of meters;
power, water, gas, or heating.

The meter interface can be delivered with two probes:
an IR probe for two way communication with supported
meters and an LED probe for interfacing to meters with
blinking LED.

The optical probe is attached either by magnets or by Velcro.
Battery lifetime is over two years with updates every five seconds.

Get started with the Meter Reader

Step 1. Open case and remove tape from batteries.

Step 2. Connect sensor part
to the main device. Make sure that it connects properly.
Device will now start blinking to let you know its open for pairing.

Scan for The Meter Reader

Step 1. Open the Wattle app and scan for device.
(More/… -> Devices -> Add new -> Scan)

Step 2. Choose configure when device displays in the scan.

Configure The Meter Reader

Step 1. Set a device name

Step 2. Add the device to a room.

Select the room you want from the list or add a new room.

Settings for: Combined interface

Usage Defaults to Generic.

Step 3. Press settings

Make sure settings are accordingly to your meter, as standard the meter reader will be setup with 1000/Electricity meter.

Step 4. Choose Apply and Apply when satisfied with configuration

Mounting The Meter Reader

Do not put main device inside of the metal box for your meter as this will degrade
the signals.

Step 1. mount main device outside of the electrical meter

Step 2. Attach velcro-tape over the Blinking LED on your power meter.
Make sure its totally centered as slightest mm offset might make reading corrupted.

Step 3. Attach sensor to the velcro-tape.

Resetting The Meter Reader

Step 1. Press and hold the button(next to green LED) inside the case. Hold for approx. 10 seconds. (until it blinks rapidly)

Step 2. Release button

Step 3. Device are now ready to be connected to a gateway.

 

Buy The Meter Reader

 

-->
back to Older Generations
newsletter

Subscribe
to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services