Heiman PIRSensor-EM

Smart Motion Sensor

Product introduction

The ultimate solution to protect your home. create your own home security system
and create rules for automation.

Detecting Areas

Tips

Please ovoid outdoor installation, places with pets. air-condition, heat source nearby.
places with direct sunshine and places under rotating objects. The installation surface
should be solid without vibration. Please install the sensor In the places where
an intruder may pass easily.

Step 1

Remove the battery insulator from product to activate. device will enter warm-up.state when red
LED flashes. After 30 seconds LED will turn off indicating warm-up is complete.

Step 2

Step 3

Add to Gateway

After starting the search in the APP, press network button (pin hole) for 3 seconds to enter Inclusion mode.
LED will flash rapidly until device ore detected by your gateway, you will see the new device appear
In the search results on your app.

If you have any problems scanning for device please refer to Disconnect from gateway/Factory reset.

Step 4

Mount the device in the area required after removing the protecting film of the double-side tape on the backside.

Step 5

Note: Please keep arrow part in the picture upwards. Put the sensor into the bracket.

Changing Battery

Please change the battery according to negative and positive of the battery.
Please deal with waste batteries correctly for environmental protection.

Technical parameters

Working Voltage: 3VDC (1xCR123A battery)
Static current: ≤15uA
Alarm current: ≤30mA
Detecting angle: 90
Install height: 2.1 m
Detecting distance: 9-12 m
Networking: ZlgBee 1.2 Home Automation
Operation temperature: -10°C ~+50°C
Relative humidity: Maximum 95%RH (no condensation)
Outline dimensions: 65 x 65 x 28.5 mm

Disconnect from gateway/Factory reset

Press and hold the network button (pin hole) for 5 seconds to disconnect/ reset the device.
The LED will flash six times to indicate successfully disconnected / reset

-->
back to Latest generation
newsletter

Subscribe
to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services