Heiman HS1DS-E

Smart Door Sensor

Smart Door Sensor

Product introduction

Detecting exits and entrances of your home

Function renderings

Step 1

Remove the battery insulator from product to activate.

Step 2

Click on the gear-symbol on your dashboard to add new device. Start device scan to search for new device.

Step 3

Add to gateway:

After starting the search in the APP, press network button (pin hole) for 3 seconds to enter inclusion mode. LED will flash rapidly until device are detected by your gateway, you will see the new device appear in the search results on your app. If any issues scanning device please refer to Disconnect / Factory reset.

Step 4

Align the installation. the installation distance is less than 15 mm (the magnet part can be installed both sides of detector part).
*Always mount indoors. The sensor is not water-proof.

Step 5

Remove the protecting film of the adhesive tape, stick the sensor ond magnet to the required area. Sensor should be installed in a fixed area like the door frame,
magnet can be installed on the active area like the door blade. Picture for reference only.

Step 6

Insert sensor into the bracket.

Changing battery

Please replace battery correctly, following the battery positive and negative electrode. Attention to environmental protection and dispose used battery properly.

Technical parameters

Operating Voltage: DC3V (2x AAA battery)

Static current: ≤5uA

Alarm current: ≤30mA

Detecting distance: >15mm

Networking: ZigBee 1.2 Home Automation

Operation temperature: -10°C ~+50°C

Relative humidity: Maximum 95%RH (no condensation)

Detector dimensions: 76 x 36.6 x 16.5 mm

Magnet dimensions: 76 x 13.9 x 16.5 mm

Disconnect/Factory reset:

Press ond hold the network button (pin hole) for 5 seconds to disconnect / reset the device. The LED will flash six times to indicate successfully disconnected / reset

 

 

 

 

 

-->
back to Latest generation
newsletter

Subscribe
to our Newsletter

receive exclusive offers and the latest news on our products and services.

  • This field is for validation purposes and should be left unchanged.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec
  • wordpress_instructions_counter

Decline all Services
Accept all Services